Scaffold Anchor Set

A scaffolding anchor set consists of:

  • Magnetic anchor
  • Magnetic protective cover
  • Product certificate
  • Wooden case

The theoretical maximum allowable load of the anchor is 2500 kgf. (Pull force)

The total weight of 1 anchor is 18 kg. The total set weights 20 kg.

The case dimensions are (LxWxH) 30x30x60 cm.

The general guideline for the number of anchors to be used is 1 anchor per 10m2 wall. We advise you to consult with us for further instructions regarding operating procedure and showcase projects.

Article nr: SAV 551.04-1400

Scaffold Installation Set

An installation set consists of:

  • 1 console 

  • 3 lanyards 

  • Ratchet and pin
  • 
1 case

Product description 


The console is a tool to place the magnet level and at exactly the desired height. It is equipped with easy to use small magnets that can be switched on manually. For further details, please consult the user manual.

The lanyards prevent the magnets, load cells, and any other pieces of equipment from falling down during installation.

The ratchet and pin serve to rotate the magnet orientation and to switch the anchor on and off.

The case is for the protection and transport of all materials. Its total weight is 6 kg, and its dimensions are 45x15x30 cm (LxWxH)

Multiple magnet anchors can be installed with a single installation set. The materials can be used and reused time and again for mounting and disassembly and any intermediate checks.

Article nr: SAV 551.10-1400

Scaffold Test Set

Test Set, with loadcells and supporting pieces to check both the magnetic pull force and slice force.

A Test set consists of: 


  • 1 load cell to determine tensile load 

  • 1 load cell to determine shear load 

  • 1 signal output unit 

  • 1 case to transport the materials.
Product description

The Controlock set consists of load cells and equipment to measure the actual maximum load the magnet can apply to the spot where it is mounted. This refers to the system’s tensile as well as shear load.

The digital output unit has been programmed to jointly register and check all anchor points, so that the scaffolding can be declared “safe” if all measured loads exceed the design specifications.

For measurements in hazardous areas, an ATEX certified unit is available on demand.

The case ensures safe transport of all materials. Its total weight is 12 kg and its dimensions are 50x40x20 (LxWxH)

A single Controlock set can be used to install multiple magnet anchors. The materials can be used and reused time and again for mounting, disassembly and any intermediate checks.

Article nr: SAV 551.18-1400